journal article Mar 04, 2019

Analysis, modeling, and implementation of a new transformerless semi‐quadratic Buck–boost DC/DC converter

Abstract
SummaryThis paper presents a novel transformerless semi‐quadratic buck‐boost converter (SQBuBoC). In the proposed SQBuBoC, two power switches with simultaneous operation are used and a higher step‐up/step‐down voltage conversion ratio is achieved compared with the traditional buck‐boost, Cuk, single‐ended primary‐inductor converter, and Zeta converters. The positive polarity of the output voltage, along with low ripple continuous input current and common ground between the source and the output voltages, are some features that make the suggested topology more suitable for many applications with wide range of output voltage such as photovoltaic systems. Moreover, the total voltage stress across the power switches in this converter is lower than the cascade boost, and the traditional buck‐boost converters led to power MOSFETs selection with lower drain‐source ON resistance (Rds) and efficiency improvement. All the steady‐state analysis and comparisons in continuous conduction mode (CCM) are discussed in details. In addition, to study the low frequency behavior of the SQBuBoC by means of the state‐space averaging technique, the small and large signal models of this converter in CCM are presented. Finally, the SQBuBoC analysis is justified using experimental results of a 50 W step‐up 25 V to 120 V and a 28 W step‐down 25 V to 14 V laboratory prototypes.
Topics

No keywords indexed for this article. Browse by subject →

References
29
[1]
Mohr M "Voltage fed and current fed full bridge converter for the use in three phase grid connected fuel cell systems" Conf Power Electron Motion Control (2006)
[4]
HasanpourS BaghramianA MojallaliH.A new high‐gain coupled‐inductor SEPIC converter for a microgrid system’ Conf the Power Electronics Drive Systems & Technologies (PEDSTC)2017;294–299. 10.1109/pedstc.2017.7910340
[6]
RenX TangZ RuanX WeiJ HuaGFour switch buck‐boost converter for telecom DC‐DC power supply applications. Applied in Power Electronics Conference and Exposition2008;1527–1530.
[10]
Luo F‐L (2010)
[14]
Erickson R‐W (2004)
[23]
NousiainenL SuntioT.Dual‐mode current‐fed semi‐quadratic buck‐boost converter for transformerless modular photovoltaic applications.Proc. Power Electronics and Applications (EPE)2011;1–10 10.1109/ecce.2011.6063886
[24]
MostaanA GorjiS‐A SoltaniM‐N EktesabiM.A novel single switch transformerless quadratic DC/DC buck‐boost converter.In Power Electronics and Applications (EPE'17 ECCE Europe)2017; P‐1 10.23919/epe17ecceeurope.2017.8099120
[27]
AyachitA KazimierczukMK.Steady‐state analysis of PWM quadratic buck converter in CCM inCircuits and Systems (MWSCAS) IEEE 56th International Midwest Symposium on 2013;49–52. 10.1109/mwscas.2013.6674582
[28]
PolivkaW ChettyP MiddlebrookR.State‐space average modelling of converters with parasitics and storage‐time modulation’ In Power Electronics Specialists Conference1980;119–143 10.1109/pesc.1980.7089440
[29]
Middlebrook R‐D "A general unified approach to modelling switching‐converter power stages" Conf Power Electron Specialists USA (1976)
Cited By
37
IEEE Transactions on Industrial Ele...
Metrics
37
Citations
29
References
Details
Published
Mar 04, 2019
Vol/Issue
47(6)
Pages
862-883
License
View
Cite This Article
Sara Hasanpour, Ali Mostaan, Alfred Baghramian, et al. (2019). Analysis, modeling, and implementation of a new transformerless semi‐quadratic Buck–boost DC/DC converter. International Journal of Circuit Theory and Applications, 47(6), 862-883. https://doi.org/10.1002/cta.2620
Related

You May Also Like