Prediction of punching shear strength of two-way slabs

Ahmed A. Elshafey; Emad Rizk; H. Marzouk; Mahmoud R. Haddara

doi:10.1016/j.engstruct.2011.02.013

journal article May 01, 2011

Prediction of punching shear strength of two-way slabs

Ahmed A. Elshafey Emad Rizk H. Marzouk Mahmoud R. Haddara

Engineering Structures Vol. 33 No. 5 pp. 1742-1753 · Elsevier BV

View at Publisher Save 10.1016/j.engstruct.2011.02.013

Topics

No keywords indexed for this article. Browse by subject →

References

52

[1]

American Concrete Institute (ACI). Building code requirements for structural concrete. ACI 318-08. Farmington Hills, Michigan; 2008.

[2]

Canadian Standards Association (CSA). Design of concrete structures for buildings. CSA-A23.3-04. Rexdale, Ontario, Canada; 2004.

[3]

British Standards Association BS 8110-85. Structural use of concrete. Use of concrete. Part 1: Code of Practice for Design and Construction. BSI. Milton Keynes, BS 8110; 1985.

[4]

Comité Euro–International Du Béton–Fédération de la Précontrainte (CEB–FIP). Model Code. Bulletin D’Information No. 203–305. Lausanne, Switzerland; 1990.

[5]

European Committee for Standardization Eurocode 2 (CEN). Design of concrete structures-Part 1.1: general rules and rules for buildings. Brussels, Belgium; 2004. 225 pp.

[6]

Bhatt P, Agar TJA. A neural network for predicting the punching shear strength of internal column-flat slab junctions without shear reinforcement. In: International workshop on punching shear capacity of RC slabs. 2000. 57, p. 39–46.

[7]

Dias "Neural networks for predicting properties of concretes with admixtures" Construct Build Mater (2001) 10.1016/s0950-0618(01)00006-x

[8]

Lee "Prediction of concrete strength using artificial neural networks" Eng Struct (2003) 10.1016/s0141-0296(03)00004-x

[9]

Kawamura "Performance evaluation of concrete slabs of existing bridges using neural networks" Eng Struct (2003) 10.1016/s0141-0296(03)00112-3

[10]

Alqedra "Prediction of shear capacity of single anchors located near a concrete edge using neural networks" Comput Struct (2005) 10.1016/j.compstruc.2005.03.019

[11]

Hoła "New technique of nondestructive assessment of concrete strength using artificial intelligence" NDT&E International (2005) 10.1016/j.ndteint.2004.08.002

[12]

Ahmadkhanlou "Optimum cost design of reinforced concrete slabs using neural dynamics model" Eng Appl Artif Intell (2005) 10.1016/j.engappai.2004.08.025

[13]

Ji "A concrete mix proportion design algorithm based on artificial neural networks" Cement Concr Res (2006) 10.1016/j.cemconres.2006.01.009

[14]

Öztaş "Predicting the compressive strength and slump of high strength concrete using neural network" Constr Build Mater (2006) 10.1016/j.conbuildmat.2005.01.054

[15]

Choi "Simplified punching shear design method for slab–column connections using fuzzy learning" ACI Struct J (2007)

[16]

Pendharkar "Neural network for bending moment in continuous composite beams considering cracking and time effects in concrete" Eng Struct (2007) 10.1016/j.engstruct.2006.11.009

[17]

Demir "Prediction of elastic modulus of normal and high strength concrete by artificial neural networks" Constr Build Mater (2008) 10.1016/j.conbuildmat.2007.04.004

[18]

Caglar "Neural networks in 3-dimensional dynamic analysis of reinforced concrete buildings" Constr Build Mater (2008) 10.1016/j.conbuildmat.2007.01.029

[19]

Trtnik "Prediction of concrete strength using ultrasonic pulse velocity and artificial neural networks" Ultrasonics (2009) 10.1016/j.ultras.2008.05.001

[20]

Alshihri "Neural networks for predicting compressive strength of structural light weight concrete" Constr Build Mater (2009) 10.1016/j.conbuildmat.2008.12.003

[21]

Caglar "Neural network based approach for determining the shear strength of circular reinforced concrete columns" Constr Build Mater (2009) 10.1016/j.conbuildmat.2009.06.002

[22]

Dahou "Artificial neural network model for steel-concrete bond prediction" Eng Struct (2009) 10.1016/j.engstruct.2009.02.010

[23]

Erdem "Prediction of the moment capacity of reinforced concrete slabs in fire using artificial neural networks" Adv Eng Software (2010) 10.1016/j.advengsoft.2009.07.006

[24]

Lee "Development of the approximate analytical model for stub-girder system using neural networks" Comput Struct (2001) 10.1016/s0045-7949(00)00199-1

[25]

Marzouk "Experimental investigation on the behavior of high- strength concrete slabs" ACI Struct J (1991)

[26]

Gardner "Relationship of the punching shear capacity of reinforced concrete slabs with concrete strength" ACI Struct J (1990)

[27]

Elstner "Shearing strength of reinforced concrete slabs" ACI J Proc (1956)

[28]

Kinnunen S, Nylander H. Punching of concrete slabs without shear reinforcement. Transactions No. 158. Royal Institute of Technology. Stockholm, Sweden; 1960. 112 pp.

[29]

Moe J. Shearing strength of reinforced concrete slabs and footings under concentrated loads. Development Department Bulletin No. D47. Portland Cement Association. Skokie; 1961. 130 pp.

[30]

Yitzhaki "Punching strength of reinforced concrete slabs" ACI J Proc (1966)

[31]

Mowrer "Shear strength of lightweight aggregate reinforced concrete flat plates" ACI J Proc (1967)

[32]

Kinnunen "Investigations on punching at the division of building statics and structural engineering" Nordisk Betong. Stockholm (1978)

[33]

Magura D, Corley W. Tests to destruction of a multipanel waffle slab structure. Full-Scale Testing of New York World’s Fair Structures. Publication 1721. Building Research Advisory Board. National Academy of Sciences. Washington DC, II; 1969. p. 10–135.

[34]

Regan P, Walker P, Zakaria K. Tests of reinforced concrete flat slabs. CIRIA Project No. RP 220. Polytechnic of Central London; 1979.

[35]

Rankin "Predicting the punching strength of conventional slab–column specimens" Proc Instit Civ Eng, Part 1 (1987) 10.1680/iicep.1987.382

[36]

Tolf P. Plattjocklekens inverkan pøa betongplattors høallfasthet vid genomstansning Försök med cirkulära platter. Bulletin No. 146. Department of Structural Mechanics and Engineering. Royal Institute of Technology. Stockholm, 64 pp. (in Swedish with summary in English); 1988.

[37]

Mongai G. A critical review of the symmetric punching shear of reinforced concrete flat slabs. Master’s thesis. University of Ottawa; 1990. 252 pp.

[38]

Tomaszewicz A. Punching shear capacity of reinforced concrete slabs. High Strength Concrete SP2-Plates and Shells. Report 2.3. Report No. STF70A93082. SINTEF. Trondheim; 1993. 36 pp.

[39]

Ramdane K. Punching shear of high performance concrete slabs. In: Proceedings of the 4th international symposium on utilization of high strength high performance concrete. Paris; 1996. p. 1015–26.

[40]

Hallgren M. Punching shear capacity of reinforced high strength concrete slabs. Bulletin 23, Department of Structural Engineering. Royal Institute of Technology. Stockholm; 1996. 206 pp.

[41]

Marzouk "Experimental investigation on shear enhancement types for high-strength concrete plates" ACI Struct J (1997)

[42]

Kevin K. Influence of size on punching shear strength of concrete slabs. Master’s thesis. McGill University. Montreal; 2000. 92 pp.

[43]

Guandalini S, Muttoni A. Symmetrical punching tests on slabs without transverse reinforcement. Test Report. École Polytechnique Fédérale de Lausanne. Lausanne. Switzerland; 2004. 85 pp.

[44]

Sundquist H, Kinnunen S. The effect of column head and drop panels on the punching capacity of flat slabs. Bulletin No. 82. Department of Civil and Architectural Engineering. Royal Institute of Technology. Stockholm, 24 pp. (in Swedish with summary and Figure captions in English); 2004.

[45]

Birkle "Influence of slab thickness on punching shear strength" ACI Struct J (2008)

[46]

Marzouk H, Hossin M. Crack analysis of reinforced concrete two-way slabs. Research Report RCS01, Faculty of Engineering and Applied Science, Memorial University of Newfoundland, St. John’s, Newfoundland; 2007. 159 pp.

[47]

Rizk E. Structural behaviour of thick concrete plates. Ph.D. thesis, Faculty of Engineering, Memorial University of Newfoundland, St. John’s, NL, Canada; 2010.

[48]

Marzouk "Fracture energy and tension properties of high-strength concrete" ASCE J Mater Civ Eng (1995) 10.1061/(asce)0899-1561(1995)7:2(108)

[49]

Marzouk "Sensitivity of shear strength to fracture energy of high-strength concrete slabs" Canad J Civ Eng (1998) 10.1139/l97-053

[50]

Staller. Analytical studies and numerical analysis of punching shear failure in reinforced concrete slabs. FIB Bulletin on Punching of Structural Concrete Slabs dedicated to Professor Sven Kinnunen. In International Workshop on punching shear capacity of reinforced concrete slabs, Proceedings, Eds.: Silfwerbrand, J.; Hassanzadeh, G.. Kungl. Tekniska Högskolan Stockholm, TRITA-BKN. Bull. 57; 2000.

Showing 50 of 52 references

Cited By

61

Punching Shear Capacity Model in Reinforced Concrete Flat Slab Without Shear Reinforcement, Based on Fracture Mechanics and Statistical Approach

Theogene Ndabamenye, John Nyiro Mwero · 2026

Engineering Reports

Machine learning for structural engineering: A state-of-the-art review

Huu-Tai Thai · 2022

Structures

Punching shear capacity of recycled-aggregate concrete slab-column connections

Saumyaranjan Sahoo, Bhupinder Singh · 2021

Journal of Building Engineering

Punching shear behavior of recycled aggregate concrete slabs with and without steel fibres

Jianzhuang Xiao, Wan Wang · 2018

Frontiers of Structural and Civil E...

Metrics

61

Citations

52

References

Details

Published: May 01, 2011
Vol/Issue: 33(5)
Pages: 1742-1753
License: View

Authors

Faculty of Engineering and Applied Science, Memorial University of Newfoundland, St. John's, Newfoundland, Canada

Cite This Article

Ahmed A. Elshafey, Emad Rizk, H. Marzouk, et al. (2011). Prediction of punching shear strength of two-way slabs. Engineering Structures, 33(5), 1742-1753. https://doi.org/10.1016/j.engstruct.2011.02.013

Prediction of punching shear strength of two-way slabs

You May Also Like