journal article Nov 14, 2018

Hydraulic properties of peat soils along a bulk density gradient—A meta study

Hydrological Processes Vol. 33 No. 1 pp. 101-114 · Wiley
View at Publisher Save 10.1002/hyp.13314
Abstract
AbstractOur understanding of hydraulic properties of peat soils is limited compared with that of mineral substrates. In this study, we aimed to deduce possible alterations of hydraulic properties of peat soils following degradation resulting from peat drainage and aeration. A data set of peat hydraulic properties (188 soil water retention curves [SWRCs], 71 unsaturated hydraulic conductivity curves [UHCs], and 256 saturated hydraulic conductivity [Ks] values) was assembled from the literature; the obtained data originated from peat samples with an organic matter (OM) content ranging from 23 to 97 wt% (weight percent; and according variation in bulk density) representing various degrees of peat degradation. The Mualem‐van Genuchten model was employed to describe the SWRCs and UHCs. The results show that the hydraulic parameters of peat soils vary over a wide range confirming the pronounced diversity of peat. Peat decomposition significantly modifies all hydraulic parameters. A bulk density of approximately 0.2 g cm−3 was identified as a critical threshold point; above and below this value, macroporosity and hydraulic parameters follow different functions with bulk density. Pedotransfer functions based on physical peat properties (e.g., bulk density and soil depth) separately computed for bog and fen peat have significantly lower mean square errors than functions obtained from the complete data set, which indicates that not only the status of peat decomposition but also the peat‐forming plants have a large effect on hydraulic properties. The SWRCs of samples with a bulk density of less than 0.2 g cm−3 could be grouped into two to five classes for each peat type (botanical composition). The remaining SWRCs originating from samples with a bulk density of larger than 0.2 g cm−3 could be classified into one group. The Mualem‐van Genuchten parameter values of α can be used to estimate Ks if no Ks data are available. In conclusion, the derived pedotransfer functions provide a solid instrument to derive hydraulic parameter values from easily measurable quantities; however, additional research is required to reduce uncertainty.
Topics

No keywords indexed for this article. Browse by subject →

References
72
[3]
Boelter D. H. (1968)
[4]
Brandyk T. (2002)
[8]
Core Team R. (2016)
[11]
Forsmann D. M. (2014)
[13]
Gnatowski T. "Hydraulic properties of fen peat soils in Poland" Geoderma (2010) 10.1016/j.geoderma.2009.02.021
[15]
Guber A. K. (2010)
[23]
Joosten H. (2012)
[28]
Leij F.J. Alves W.J. Van Genuchten M. Th. &Williams J.R.(1996).Unsaturated soil hydraulic database UNSODA 1.0 user's manual. Report EPA/600/R96/095. US Environmental Protection Agency Ada OK 103 p.
[33]
Changes in flow and transport patterns in fen peat following soil degradation

H. Liu, M. Janssen, B. Lennartz

European Journal of Soil Science 10.1111/ejss.12380
[39]
A new model for predicting the hydraulic conductivity of unsaturated porous media

Yechezkel Mualem

Water Resources Research 10.1029/wr012i003p00513
[45]
Päivänen J. "Hydraulic conductivity and water retention in peat soils" Acta Forestalia Fennica (1973)

Showing 50 of 72 references

Cited By
135
Peatland Mid-Infrared Database

Henning Teickner, Svenja Agethen · 2026

Scientific Data
Environmental Research Letters
Ecological resilience of restored peatlands to climate change

Julie Loisel, Angela Gallego-Sala · 2022

Communications Earth & Environm...
Metrics
135
Citations
72
References
Details
Published
Nov 14, 2018
Vol/Issue
33(1)
Pages
101-114
License
View
Funding
Deutsche Forschungsgemeinschaft Award: DFG‐GRK 2000/1
European Social Fund Award: ESF/14‐BM‐A55‐64160024/16
Cite This Article
Haojie Liu, Bernd Lennartz (2018). Hydraulic properties of peat soils along a bulk density gradient—A meta study. Hydrological Processes, 33(1), 101-114. https://doi.org/10.1002/hyp.13314